Give Thanks

Give Thanks

If you haven't figured it out yet, I am in love with the Copper Foil.  If I could, I would use it on everything!  And I especially love this piece from the Paisley framelits when I cut it from the Copper makes the most perfect tie-on!

Step by Step

For this project, you'll need the following cardstock cut to these sizes:

4-1/4" x 11" Night of Navy (card base)

3-3/4" x 1-1/2" Petals & Paisleys Specialty Designer Series Paper

3-3/4" x 3-3/4" Petals & Paisleys Specialty Designer Series Paper

2-1/2" x 3-1/4" Very Vanilla cardstock

Scrap Copper Foil

1) Stamp sentiment using Rich Razzleberry ink onto Very Vanilla cardstock.  Use Big Shot to cut sentiment from Layering Ovals framelits set and Copper Foil piece from Paisley framelits.  Use sponge dauber to ink edge of Very Vanilla piece using Mint Macaron ink.

2)  Punch 9-10 circles with the 1/2" circle punch out of Copper Foil.  On back side of larger DSP paper, attach circles along one edge to create a scallop on the front side.  Attach scallped edge over smaller piece of DSP to create a single layer measuring 3-3/4" x 5".  On backside, put two dabs of adhesive where your ribbon will go.  Adhere end of ribbon to one dab, wrap around front of card and adhere to other adhesive dab.  Cut ribbon.

3)  Adhere DSP to card base.  Adhere sentiment to card front using Stampin' Dimensionals.  Attach Copper Paisley tie-on with linen thread.

These are the products I used for this project: 


Shop Now


I used the Layering Ovals again...don't forget those are on the Special Offers list this week at 25% off!  This special ends on September 21 so make sure you order yours before they go back to full price! 

Until next time...happy stampin'!

Leave your comment

Comments have to be approved before showing up